Lectrosonics PT3 - Manual (Page 14)

5. From the main window’s Action Map frame, click
New... again. Change the settings to translate MIDI note
62 (the D above middle C) to the AM8’s Auto/Direct All
Direct action, as shown. When invoked, this action will
instruct the AM8 to set all inputs to Direct mode, lighting
all eight channel status LEDs.
Click OK when done. A summary of the new translation
should appear in the main window’s action map, as
shown in the figure for step 7.
6. From the main window’s Action Map frame, click
New... again. Change the settings to translate MIDI note
64 (the E above middle C) to the AM8’s Auto/Direct All
Auto action, as shown. When invoked, this action will
instruct the AM8 to set all inputs to Auto mode, extin­
guishing all eight channel status LEDs (provided there is
no input signal).
Click OK when done.
7. Your main window should now
look like this. If your PT3 is not
connected, the PT3 Status frame
will show “Not Connected” instead
of “Ready”.
From the File menu, select Save
to save your settings to a disk file.
You may use any name you wish
(up to 8 characters) and save the
file in any directory that is appro­
priate.
14