LevelOne FCS-8006 - Manual (Page 76)

Intelligent Surveillance Solution
LevelOne IP CamSecure
- 75 -
Advanced Setting
I/O Device Setting:
 Module Setting: Name the module device and ID that has been connected to the digital input/output
device(s) to your system.
 Device: This column displays the device(s) already installed to the system.
 ID: Select the number of the I/O port to which you plug the ribbon cable.
Input Monitor: The device(s) is turned on if the dot is red. By triggering the digital input device, the related
icon will light up. This is used to check that the device is correctly connected.
Output Monitor: The device(s) is turned on if the dot is red. By clicking on the icon, you may trigger the digital
device connected to the system. This can be used to test if the output device is correctly connected.
Device Setting
 Name: Insert the name of the device (input and output).
 Type: Select the device type from the drop-down menu.
1. N/O: Normal Open.
2. N/C: Normal Close.
 Associated Camera: You may assign one camera to each digital input device. Smart Guard will
collect snapshots from these cameras upon certain triggered events. For details please refer to 4.2 -
Action. DI’s included with IP cameras will keep its own camera as default associated camera.
5.4 Setting - PTZ Config
Install PTZ cameras and follow the instructions of the camera manufacturer. A PTZ camera is usually
connected to the PC with RS-485/RS-422.
Basic Setting
Miscellaneous
Output Monitor
Input Monitor
List of devices
I/O Device Setting