LiftMaster TAC2D TAC Retrofit System for *1812 - Manual (Page 3)

3
CODE SETUP
The unit’s Master Code is for owner/administrator level commands. The User Codes allow users
to activate and latch relays 1 and 2.
NOTE: The User Code cannot be the same as the Master Code.
PROGRAMMING
» KEYPAD
TRIGGER RELAY 1 (ONLY)
Enter the Master Code: ? ? ? ?
NOTE: Requires Relay 2 be in Independent Mode.
ENABLE VACATION (LOCK DOWN) MODE
Locks the unit from all User Code activity.
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 5 2
DISABLE VACATION (LOCK DOWN) MODE
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 5 3
TRIGGER RELAY 2
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 2
CODE OPERATION
MASTER CODE OPERATIONS
TRIGGER PROGRAMMED RELAY FOR USER CODE
Enter the User Code: ? ? ? ?
The Relay will activate.
USER CODE OPERATIONS
ENTER A TEMPORARY (1 SHOT) USER CODE NUMBER
The unit holds 1 temporary User Code.
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 5 1 The unit will beep.
3. Enter the Temporary User Code:
4. Enter the Relay for the Code to control: 1 or 2 or no
button is pressed.
NOTE: If no button is pressed in step 4, both relays will
activate simultaneously. Expires in 24 hours or after
fi rst use.
ENGAGE PARTY MODE (RELAY 1)
Party Mode will latch relay.
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 5 4
To disengage party mode: Enter a valid code into the keypad
or enter “*9” into the local telephone.
ENGAGE PARTY MODE (RELAY 2)
Party Mode will latch relay.
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 5 6
To disengage party mode: Enter a valid code into the keypad
or enter “*5” into the local telephone.
NOTE: Relay 2 must be in Independent Control Mode to
engage Party Mode on relay 2. See page 2.
ENTER A USER CODE NUMBERS
1. Enter the Master Code: ? ? ? ? The unit
will beep.
2. Enter the Program Code: 9 The unit will beep.
3. Enter New User Code:
4. Enter the Relay for the Code to control: 1 or 2 or no
button is pressed.
NOTE: If no button is pressed in step 4, both relays will
activate simultaneously.
DELETE USER CODE NUMBERS
1. Enter the Master Code: ? ? ? ? The unit will
beep.
2. Enter the Program Code: 7 The unit will beep.
3. Enter User Code to be deleted:
1. Enter the Master Code: ? ? ? ?
2. Enter the Program Code: 1
TRIGGER RELAY 1