Qualcraft Residential Safety Netting - Manual

Step 1. Choose the appropriate safety net by measuring the width and length of the work area to be pro-
tected. The net structure is supported with three sets of reinforcement ropes affording up to twenty-five
dimensional adjustments in width and length. Lay the net on the floor and choose the appropriate perimeter
rope to be used for fastening the net over the work area.
Note:
If plumb and line braces need to be removed to complete installation of the safety net, insure that the
Foreman for that job is present and that the braces are reinstalled properly.
Caution:
Care must be taken not to draw the walls in toward the net when the straps are tightened.
Temporary reinforcement of the frame work may be necessary, taking into consideration the weight and stress
of the net in use. Safe practices must always be used when employing the use of ladders, hoists and scaf-
folding during installation and removal of the net.
Installation Instructions
Interior Residential Contractor’s Safety Net
I nternational Cordage East
226 Upton Road
Colchester, CT 06415
860-537-1414
800-596-1066
Fax 860-537-7393 www.incord.com
[email protected] Installation Instructions 104
5-23 Rev. A
Copyright © 2006 I
N C ORD
The I N C ORD Interior Residential Contractor’s Safety
Net System eliminates the need for interior scaffold-
ing in clear story/balloon framed areas. The safety
net is easy to setup, remove and store. Constructed
of rugged high-strength fiber netting with integrated
rope cording, the safety net is held in place over the
work area with rope and adjustable cinch straps.
Unpack the net and check for any cuts or tears in
the net or rope cording. Contact I
N
C
ORD
if any por-
tion of the net is damaged. Read all Instructions
before setting up the Interior Residential Safety Net.
page 1-2
Note: Cinch Strap is
threaded from the
bottom up as shown
with the “PRESS”
tab on top.