Thermolec Split|Steam - Manual (Page 11)

Page 9
8.5 Pull the plastic tube attached to the bottom of the unit out of the rigid drain pipe on the wall. You do not
have to remove the plastic tube attached to the bottom of the pan. Remove the overfl ow pan from the unit by
slightly loosening the front screw then lifting the front of the pan off the screw and pulling it towards you. Please
see Fig. 8a. Remove the main drain tube from the rigid drain pipe attached to the wall and check that they are
both clean and clear from deposits.
8.6 Check that the water tank is not too hot to handle. Unfasten the latch around the water tank and remove
the tank from the main body of the humidifi er by pulling it down. When you remove the tank, it is possible to
clean the round o-ring gasket, but don’t discard it.
NOTE :This round gasket is mandatory and the unit will not work properly without it.
8.7 Soap or vinegar can be used to clean the water tank, the heating element and the tips of the level
sensors. Other cleaning products used to remove scale, lime or calcium are also available on the market, but
DO NOT use a metal brush or any strong acids to clean the tank as they may damage the stainless steel.
8.8 Once completed, reinstall the round gasket around the water tank collar. Please see Fig. 8b. Align the
two arrows located at the front of the tank and the fi xed part while lifting the tank in place. Please see Fig.8c.
Apply even pressure to secure the tank properly in the top part. Then close the latch holding the tank in
position. Verify that the o-ring gasket and tank are seated properly.
Fig. 8b
Fig. 8c
HOME OWNER HOME OWNER