Seed Hawk GRANULAR AND LIQUID TANKS 2009 - Manual (Page 54)

Seed Hawk Manual Granular and Liquid Tanks Page 52
9.6 METER SETTINGS
9.6.1 Meter Selection
Select which Meter you would like to view or make changes to.
Note: All Meters on a machine must be individually calibrated. Calibrations
must be done each time a crop is changed.
9.6.2 Pulses Per Rev
This is the number of pulses produced by
the meter sensor in one revolution. The
default setting is 80. If using a setup other
than a standard Seed Hawk configuration
this setting may need to be changed. To
change this setting use the up/down arrow
keys to highlight the line “Pulses Per Rev
80” and press the select button. “80” will
now be highlighted and can be changed
using the up/down arrow keys. Once the
desired value is on the screen press the
SELECT button again and the highlight bar
will move to the “Low Alarm Point” bar.