Detcon 700 Sensor Duct Mount Kit - Manual (Page 6)

700 Duct Mount
Model 700 Duct Mount Kit Rev.1.2 Page 2 of 5
3.0 Installation
1. Cut clearance hole in duct as shown below. Cutout is the same for square or round ducts. Minimum
suggested diameter for round duct is 10 inches to adapt with normal mounting techniques. Adapting to
an 8” diameter duct is possible with special mounting techniques. Below 8” diameter is not practical
for mounting.
2. Mount the duct mount kit using four 1/4” sheet metal bolts or other appropriate hardware.
3. If necessary you may enhance mounting integrity by using the two holes on the upper right portion of
the duct mount plate. Use standoffs and 1/4” sheet metal bolts or other appropriate hardware.
4. Perform installation wiring as described in the sensor assembly instruction manual. Use flexible
conduit to allow for future maintenance.
Figure 2 Duct cutout dimensions