In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 9)

Mounting the Controller 9
Chapter 3 Mounting the Controller
Danger
Only properly trained and qualified personnel should
install the Con TROLL instrument described in this manual.
This instrument should be installed for use in non-
hazardous locations only.
Danger
L'installation de l'appareil “Con TROLL” décrite dans le
guide d'utilisateur doit impérativement être réalisée par
des personnes qualifiées. L'installation de cet appareil est
seulement prescrite pour des emplacements sans risques.
3.1 OPTIONAL MOUNTING KIT
The In-Situ Con TROLL mounting kit (Cat. No. 0087562) contains the
following:
• Two stainless mounting brackets
• Two 1½-3½ in-diam. hose clamps
• One package containing mounting tabs (4), nuts (4), and screws(4)
• DIN rail mounting brackets
The nuts and screws supplied with the mounting tabs are suitable for use
with the mounting brackets.
FIGURE 3. Con TROLL mounting kit
Mounting tabs (4), nuts,
Mounting
Hose clamps
and screws
brackets
DIN mounting
clips (2) and
screws (4)