In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 7)

Overview 7
Chapter 2 Overview
All Con TROLL
®
PRO modules have the following benefits:
• NEMA 4X rated
• Robust keypad and display window
• Easy-to-use controller software
• Optional C-cell alkaline battery backup
For a complete list of controller specifications, see “Specifications” on
page 31.
2.1 AVAILABLE MODELS
The Con TROLL PRO process controller module is available in three models:
• Con TROLL PRO Model DC-L, a battery- or solar-powered controller
with logging abilities. This model requires a 9-36 VDC ( ) 0.2 A max
supply as the primary power source. It is suited for remote applications
and can trigger low voltage relays.
• Con TROLL PRO Model AC, a 100–240 VAC (~), 0.15 A, 50–60 Hz-
powered controller capable of displaying and transmitting data. This
model is suited for applications with access to line power that do not
require logging abilities. This model can trigger low and high voltage
relays.
• Con TROLL PRO Model AC-L, 100–240 VAC (~), 0.15 A, 50–60 Hz-
powered controller capable of logging, displaying, and transmitting data.
This model is suited for applications with access to line power that require
logging abilities. This model can trigger low and high voltage relays.
2.2 BOX CONTENTS
Note: After verifying that the
contents of the box are
complete, place the controller
back in the box for transport
to the installation site. Remove the controller from the shipping box. The shipping box should
contain:
• Controller (1)
• Controller plugs (5)
• Dome connectors (3)
• O-rings (6)
• Large lock nuts (6)
• Sealed desiccant pack (1) that will be placed in the installed controller.
• Opened desiccant pack (1) that protected the instrument during shipping.
Discard after opening the controller.
Figure 1 shows the DC-powered model. Figure 2 shows the AC-powered
models.