Removing p9000 application performance extender, Removing the management station, Removing the communication agent – HP XP Application Performance Extender Software User Manual
Page 25: 25 removing the communication agent
The End User License Agreement is displayed.
6.
Read and accept the terms of the agreement.
The Pre–installation summary is displayed. Follow the instructions to proceed.
Windows host
1.
Double-click P9000APEX_Controller.exe to start the installation.
The Installation Wizard is displayed.
2.
Click Next.
The following message is displayed:
An earlier version of APEX Controller is installed on the machine.
Press OK to Upgrade.
3.
Click OK.
The License Agreement window is displayed.
4.
Read and accept the terms of the license agreement, and click Next.
The Pre–installation Summary window is displayed.
5.
Click Install to proceed.
When the installation is complete, the Installation Summary window is displayed.
6.
Click Done.
Removing P9000 Application Performance Extender
Removing the management station
NOTE:
Removing the management Station will also remove Postgre SQL 8.3.
To remove the P9000 Application Performance Extender management station:
1.
Select Start > Control Panel > Add/Remove Programs.
2.
Select HP StorageWorks P9000 Application Performance Extender Management Station.
3.
Click Remove.
Removing the communication agent
Removing the communication agent on HP-UX and Linux hosts
To remove the communication agent on HP-UX and Linux hosts:
1.
Using the command-line interface, navigate to the following location:
/opt/Hewlett-Pacard/APEX/com_agent/Uninstall_APEXCommunicationAgent
2.
Run the ./UninstallAPEXCA command.
HP StorageWorks P9000 Application Performance Extender Software User Guide
25