2 auto device placement, Evice, Lacement – HP Radio Frequency Planner Software Series User Manual
Page 71
Table of Contents
HP RF Planner User Guide
64
Figure 78.
Capacity Planning Summary – Passed? (Orange)
•
If the Capacity Feasibility Check is ‘Failed!’, Planner also gives the potential reason for the failure.
Figure 79.
Capacity Planning Summary – Failed!
Click <Failed> to view the reason for failure. The ‘What-If Scenario Analysis’ is useful to understand the reason for
failure.
Conditions for failure:
If the expected capacity you specified is greater than the estimated capacity without Wi-Fi interference, the
planned capacity is not feasible.
If the expected capacity you specified is greater than the estimated capacity with Wi-Fi interference, the planned
capacity is not feasible.
Once you click <Finish> in either of the above summary screens, Planner starts
explained in detail in
the next section.
6.2
Auto Device Placement
Planner considers the following factors during Auto Device Placement.
•
Whether there are any Area Polygons defined.
If an Area Polygon is defined, Planner tries to place the calculated number of devices within the Area Polygon.