To ping an ip address, Configuring the ip address manually, Using dhcp – HP StoreVirtual 4000 Storage User Manual
Page 55: Configuring the ip address manually using dhcp
To ping an IP address
1.
Select a storage system, and open the tree below it.
2.
Select Network.
3.
Click TCP/IP Tasks, and select Ping.
4.
Select which network interface to ping from, if you have more than one enabled.
A bonded interface has only one interface from which to ping.
5.
Enter the IP address to ping, and click Ping.
If the server is available, the ping is returned in the Ping Results window.
If the server is not available, the ping fails in the Ping Results window.
Configuring the IP address manually
Use the Network category to add or change the IP address for a network interface.
1.
Select a storage system, and open the tree below it.
2.
Select Network.
3.
Select the interface from the list on the TCP/IP tab for which to configure or change the
IP address.
4.
Click TCP/IP Tasks and select Edit.
5.
Select IP Address, and complete the boxes for IP address, Subnet mask, and Default gateway.
6.
Click OK.
7.
Click OK on the confirmation message.
8.
Click OK on the message notifying you of the automatic log out.
NOTE:
Wait a few moments for the IP address change to take effect.
9.
Log in to the newly addressed storage system.
Using DHCP
A DHCP server becomes a single point of failure in your system configuration. If the DHCP server
goes offline, then IP addresses may be lost.
CAUTION:
If you use DHCP, be sure to reserve statically assigned IP addresses for all storage
systems on the DHCP server. This is required, because management groups use unicast
communication.
NOTE:
If you plan to bond the NICs, you must use a static IP address.
To set IP address using DHCP
1.
Select a storage system, and open the tree below it.
2.
Select Network.
3.
Select the interface from the list on the TCP/IP tab for which to configure or change the
IP address.
4.
Click TCP/IP Tasks and select Edit
5.
Select Obtain an address automatically using the DHCP/BOOTP protocol.
6.
Click OK.
7.
Click OK on the confirmation message.
8.
Click OK on the message notifying you of the automatic log out.
NOTE:
Wait a few moments for the IP address change to take effect.
Configuring the IP address manually
55