Manley SLAM! - Manual (Page 20)

LED Meter Trims (This is done in MODE 2)
1) With 0VU, adjust AUDIO PEAK trim (sidechain board) for 4 segments lit. Increase oscillator by
6 dB & Be sure L&R are even. Verify 10 segments lit (4th dot from top), adjust AUDIO PEAK trim
if needed.
2) Kill oscillator verify no segments lit. Verify -20 dB in lights the first segment.
3) Set LED to GR. With FET LIMIT at 9:00 adjust for 4 Yellow segments lit. Be Sure L&R are
even.
4) Use music to verify display is nice, balanced and no segments are dead. Go through Mode 1 Peak
and GR, verify in GR both FET and OPTO are displayed. Do the same for Mode 2 Peak and GR. 5)
Go to Mode 3, verify LED TRIM (front panel) changes color change point. Leave trim in middle of
range. (Factory default 3 Yellow led’s lit ) TO ADJUST :
A.- Go to mode 3 (left bar lits)
B.- Hit reset one more time fast.(left bar flashes) Adjust LED TRIM middle of range.
C.- Hit reset one more time fast.(left bar stop flashes) Adjust LED TRIM for three yellow segments
lit.
D.- Go to mode 2. (Mode 2 Factory default)
6) Go to Mode 4, verify Peak, Peak Timed and Peak Hold modes. (Mode 4 Peak Timed Factory
default)
7) Power down, hold MODE TOGGLE down, and power up to return to default settings.
Holding the toggle down as you turn power on resets the LED meter to factory defaults.
Holding the toggle down as the meter does its opening dance displays the software version. If the left
display shows 3 LEDs and the right shows 2, you have LED Meter Software Version 3.2.
20