Changing the settings – Vaisala WXT510 User Manual
Page 112
User’s Guide ______________________________________________________________________
110 _________________________________________________________________ M210470EN-D
Example (ASCII and NMEA 0183, device address 0):
0SU<cr><lf>
0SU,R=11110000&11000000,I=15,S=Y,H=Y<cr><lf>
Example (SDI-12, device address 0):
0XSU!0XSU,R=11110000&11000000,I=15,S=Y,H=Y<cr><lf>
Changing the Settings
You can change the following settings:
-
parameters included in the supervisor data message,
-
update interval,
-
error messaging on/off, and
-
heating control.
Make the desired setting with the following command. Select the
correct value/letter for the setting fields, see
Setting Fields on page 109
.
See the examples.
Command format in ASCII and NMEA 0183:
aSU,R=x,I=x,S=x,H=x<cr><lf>
Command format in SDI-12;
aXSU,R=x,I=x,S=x,H=x!
where
R, I, S, H
=
The supervisor setting fields, see
Setting Fields on
page 109
.
x
=
Value for the setting
<cr><lf>
=
Command terminator in ASCII and NMEA 0183
!
=
Command terminator in SDI-12