VariZoom VZSNAPCRANE9-100 - Manual (Page 3)

3
TRIPOD & DOLLY SETUP
Before assembling your crane, make sure the dolly is on a completely flat,
level surface. Insert the tripod feet into the dolly receivers.
For maximum stability, extend the tripod feet so they snugly fit toward the
outer edge of the receivers and the spreader is flattened out.
PAN/TILT BASE
First, you will need to attach the base unit to the tripod. Unscrew the
base mounting knob and insert the base into the tripod.
Re-attach the base mounting knob securely, making sure the base is
seated correctly. Check the bull’s-eye level and adjust the tripod
leveling feet as necessary.
Position the dolly/tripod –***To prevent toppling, ONLY push at the
base of the legs (not up high)*** Based on the crane configuration,
you can estimate how much of a radius you will need to operate.
Reposition the dolly/tripod based on your situation, lining up a forward-pointing tripod leg with the
crane’s forward rest/default direction (this will maximize stability). For safety, engage the dolly wheel
brakes before continuing assembly.
Pull both T-handle pins out by pressing in on the blue button and pulling out on the t-handle. Let the
pins hang by their lanyards.
Pivot Section
The pivot section is the sub-section that attaches to the pan/tilt base.
To install the pivot section of the crane, slide it into place between the arms of the base, aligning the
pivot holes.
Make sure the brake knob and brake plate (half-
moon) are on the same side so the brake plate will
slide into the clamping mechanism.
Align the hole on the pivot section with the hole right
above the brake knob on the base. While depressing
the button, slide the thicker t-handle pin all the way
through the base and pivot section.