AVE Video Serial Synchronous ATM Interface VSSI-PRO - Manual (Page 41)

41
PROGRAMMING THE VSSI-PRO
VSSI-Pro VIDEO SERIAL ATM INTERFACE
Figure 47: TRANSMIT [ TX ] TEST Display
Figure 48: RX/TX TEST Display
Press “Set” to return to the previous menu.
RX/TX TEST
In the RX/TX Test, the VSSI-Pro echoes whatever it receives to further test the hardwire connections of the system. Press
the “Up” or “Down” button to move the cursor to "RX/TX TEST" and press "Set". The following display will appear
(example only):
The VSSI-Pro is now waiting for data from the ATM. Enter a transaction. If the VSSI-Pro is receiving data, it will appear in
three separate lines, scrolling from right to left across the bottom of the on-screen display. The first line is the transaction
information. The second and third lines represent the HEX equivalent of the data in the first line.
0 Data
3 HEX MS nibble
0 HEX LS nibble
If you perform this test and do not receive any data then check all connections to the VSSI-Pro.
TRANSMIT [ TX ] TEST
In the Transmit Test, the VSSI-Pro sends a predefined ASCII pattern to further test the hardwire connections of the
system. P
ress the “Up” or “Down” button to move the cursor to " TRANSMIT [ TX ] TEST" and press "Set". The following
display will appear (example only):
RX BAUDRATE : 19200
TX BAUDRATE : 19200
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
ECHOING :
RX BAUDRATE : 19200
TX BAUDRATE : 19200
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
TRANSMITTING :
Press “Set” to return to the previous menu.
NOTE
" " " " "
In any of these tests, you can pause the data scrolling by holding down either the “Up”or
“Down” button.