Vollrath CF101 - Manual (Page 21)

15
4.3 TROUBLESHOOTING TABLES
PROBLEM POSSIBLE CAUSE REMEDY
Custard is running
too cold or auger
blades chatter
during running.
1. Flow is not high enough.
2. Hopper is low or out of mix.
3. Flow valve is plugged.
4. The refrigeration system is set too cold
for the mix.
1. Increase the flow. Machine needs to run for at
least a minute before you see a change in the
product.
2. Add Mix
3. Check flow valve.
4. Call Stoelting service department and we can
help over the phone to adjust setting properly.
Custard is running
too soft.
1. Flow is too high.
2. Flow valve is plugged.
3. The refrigeration system for that barrel
set too warm for the mix.
4. Condenser on remote unit is blocked.
5. Water cooled machine has water shut
off.
6. Refrigeration system not functioning
correctly.
1. Decrease the flow. Machine needs to run for at
least a minute before you see a change in the
product.
2. Check flow valve.
3. Call Stoelting service department and we can
help over the phone to adjust setting properly.
4. Check for blockage and clean if necessary.
5. Check that water is connected and turned on.
6. Call Stoelting service department.
Beater motor
freezes up in the
run mode.
1. Hopper is low or out of mix.
2. Flow valve is plugged.
3. Flow valve is set too low.
4. Belt is loose and slipping. 1. Add Mix
2. Check flow valve.
3. Increase the flow setting.
4. Check the belt and tighten if necessary.