Lenovo ThinkVantage (Rescue and Recovery 4.5) - Manual (Page 76)

Table 33. \Rescue and Recovery\Settings\Backup (continued)
Policy Setting Description
VerifyDisc Enable or disable Verify Disc when backing up
to a CD/DVD or creating an archive to those
media. Default: Enabled.
BatteryPercentRequired Battery Percent Required is essential before
commencing a scheduled backup. This policy
ensures there is enough battery power left to
complete a backup. Values: 0-100. Default: 0.
SkipLockedFiles Enable or disable Skip Locked Files when
backing up. If enabled, locked files will not be
backed up. Default: Disabled.
MinPercentFreeSpace The minimum percentage of free space on the
destination drive required for backup. Values:
0-100. Default: 0.
ProtectWithPassword Enable or disable the Protect With Password
option. If enabled, backups will be protected
with a password. Default: Disabled.
RequiredGBFreeSpace Set the amount of free space in GB that is
required for a backup to occur.
AutosyncRetryNetwork Number of minutes before the user will be
prompted again after the user chooses not to
retry an auto-synchronization to Network.
Prebackup is used when the user wants to run any applications or script before the Rescue and Recovery program
starting a backup.
PreBackup Pre Command to run prior to a backup operation.
Include the full path to the file, if that path is
not in the environment variable. Default: None.
PreBackup PreParameters The parameter that passes the command that
is run prior to a backup operation. Default:
None.
PreBackup PreShow Show or hide the command that is run prior to
a backup operation. Default: Show.
Postbackup is used to run applications or script when a backup operation is finished. When in Windows Vista or
Windows 7 operating system, make sure that the application or script is not interactive. Otherwise, all graphic user
interfaces will pop up on the Windows service session, and they will not be focused to the user. This is the design of
the Microsoft Windows operating system.
PostBackup Post Command to run after a backup concludes.
Include the full path to the file, if that path is
not in the environment variable. Default: None.
PostBackup PostParameters The parameter that passes the command that
is run following the conclusion of a backup.
Default: None.
PostBackup PostShow Show or hide the command that is run following
a backup operation. Default: Show.
Restore
The following table provides the policy settings for Restore.
70 Rescue and Recovery 4.5 Deployment Guide