3controls and displays, 1operating and control elements, 2temperature display – Liebherr IGN 2566 Premium NoFrost User Manual

Page 4: 4putting into operation, 1transporting the appliance, 2installing the appliance, 3 controls and displays, 4 putting into operation, Controls and displays, 1 operating and control elements

Advertising
background image

-

Avoid lasting skin contact with cold surfaces

or refrigerated/frozen food or take protective

steps, e.g. wear gloves. Do not consume ice

cream, water ice or ice cubes immediately

and do not consume them too cold.

Danger of injury and damage:

-

Hot steam can lead to injury. Do not use elec-

trical heating or steam cleaning equipment,

open flames or defrosting sprays to defrost.

-

Do not use sharp implements to remove the

ice.

Please observe the specific information in

the other sections:

DANGER

identifies a situation involving direct

danger which, if not obviated, may

result in death or severe bodily

injury.

WARNING

identifies a dangerous situation

which, if not obviated, may result in

death or severe bodily injury.

CAUTION

identifies a dangerous situation

which, if not obviated, may result in

minor or medium bodily injury.

NOTICE

identifies a dangerous situation

which, if not obviated, may result in

damage to property.

Note

identifies useful information and tips.

3 Controls and displays

3.1 Operating and control elements

Fig. 2

(1) Temperature display

(5) SuperFrost button

(2) Down setting button

(6) Alarm button

(3) Up setting button

(7) Child-proofing symbol

(4) On/Off button

3.2 Temperature display

The following are displayed in normal operation:

-

the warmest freezing temperature

The temperature display flashes:

-

the temperature setting is being changed

-

after switch-on the temperature is not yet cold enough

-

the temperature has risen several degrees

Dashes flash in the display:

-

the freezer temperature is above 0 °C.

The following displays indicate malfunction. Possible causes

and corrective action (see Malfunction).

-

nA

-

F0

to

F5

4 Putting into operation

4.1 Transporting the appliance

CAUTION

Risk of injury and danger of damage as a result of incorrect

transport!

u

Transport the appliance in a packed condition.

u

Transport the appliance upright.

u

Do not transport the appliance without assistance.

4.2 Installing the appliance

WARNING

Risk of fire due to short circuit!

If the mains cable/connector of the appliance or of another

appliance touch the rear of the appliance, the mains cable/

connector may be damaged by the appliance vibrations,

leading to a short circuit.

u

Stand the appliance so that it is not touched by connectors

or main cables.

u

Do not plug the appliance or any others into sockets located

near the rear of the appliance.

WARNING

Fire hazard due to dampness!

If live parts or the mains lead become damp this may cause

short circuits.

u

The appliance is designed for use in enclosed areas. Do not

operate the appliance outdoors or in areas where it is

exposed to splash water or damp conditions.

u

Only use the appliance when it is installed.

WARNING

Fire hazard due to refrigerant!

The refrigerant R 600a is environmentally friendly but flam-

mable. Escaping refrigerant may ignite.

u

Do not damage the piping of the refrigeration circuit.

WARNING

Fire hazard and danger of damage!

u

Do not place appliances emitting heat e.g. microwaves,

toasters etc. on the appliance!

q

In the event that the appliance is damaged, contact the

supplier immediately before connecting to the mains.

q

The floor at the site must be flat and level.

q

Do not install the appliance in a location where it is exposed

to direct radiation of the sun, next to a cooker, heater and

similar.

q

Do not install the appliance without assistance.

Controls and displays

4

* Depending on model and options

Advertising