Liebherr IGN 2566 Premium NoFrost - Manual (Page 8)

5.14.1 Using cold storage accumulators
u Place the cold storage accu-
mulators in the top freezer
compartment to save space.
u Place the frozen cold storage
accumulators on the frozen
food in the upper front area of
the freezer compartment.
5.15 IceMaker*
The IceMaker is in the fourth drawer from the top. The drawer
is marked “IceMaker”.
Make certain that the following conditions are met:
- The appliance is level.
- The appliance is connected.
- The IceMaker is connected to the water supply.
5.15.1 Switching on the IceMaker*
Fig. 6
u Pull out the drawer.
u Press the On/Off button Fig. 6 (1) so that the LED Fig. 6 (2)
shines.
u Push in the drawer.
Note
u The IceMaker produces ice cubes only if the drawer is fully
closed.
5.15.2 Producing ice cubes*
The production capacity depends on the freezer temperature.
The lower the temperature, the more ice cubes can be
produced in a specific period.
The ice cubes drop from the IceMaker into the drawer. When a
certain filling level has been reached, no further ice cubes are
produced. The IceMaker does not fill the drawer right up to the
brim.
If large quantities of ice cubes are needed, the complete
IceMaker drawer can be exchanged for the adjacent drawer.
When the drawer is closed, the IceMaker automatically re-
commences production.
Once the IceMaker has been switched on for the first time, it
may take up to 24 hours until the first ice cubes are produced.
Note
When the appliance is used for the first time and if it has been
out of use for a long time, particles may collect in the IceMaker
and/or water conduit.
u Therefore do not use or consume the ice cubes made in the
first 24 hours.
5.15.3 Switching off the IceMaker*
When the IceMaker is switched off, the IceMaker drawer can
also be used for freezing and storing food.
u Press the On/Off button for about 1 second until the LED
goes out.
u Clean the IceMaker.
w This ensures that no water or ice remains in the IceMaker.
6 Maintenance
6.1 Defrosting with NoFrost
The NoFrost system automatically defrosts the appliance.
The moisture condenses on the evaporator, is periodically
defrosted and evaporates.
u The appliance does not have to be manually defrosted.
6.2 Cleaning the appliance
WARNING
Risk of injury and damage as a result of hot steam!
Hot steam can lead to burns and can damage the surfaces.
u Do not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
u Do not use cleaning agents in concentrated form.
u Do not use any scouring or abrasive sponges or steel wool.
u Please do not use any aggressive, scouring, sand-,
chloride-, chemical- or acid-based cleaning agents.
u Do not use chemical solvents.
u Do not damage or remove the type plate on the inside of the
appliance. It is important for the customer service.
u Do not pull off, bend or damage cables or other compo-
nents.
u Do not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
u Please use soft cleaning cloths and a universal pH-neutral
cleaning agent.
u Please use cleaning and care products suitable for contact
with foodstuffs in the appliance interior.
u Empty appliance.
u Pull out the power plug.
u Clean plastic outer and inner surfaces with lukewarm
water and a little washing-up liquid.
u Clean items of equipment by hand with lukewarm water
and a little washing-up liquid.
u Only use a damp cloth to clean the telescopic rails. The
grease in the runners is for lubrication purposes and must
not be removed.
After cleaning:
u Wipe dry the appliance and items of equipment.
u Connect the appliance and switch it on again.
u Switch on SuperFrost (see 5.8) .
When the temperature is sufficiently cold:
u Put the food back inside.
6.3 Cleaning the IceMaker*
Fig. 7
The IceMaker has to be switched on.
u Pull out the drawer and remove the ice cubes.
u Clean the drawer with warm water and mild washing-up
liquid.
Maintenance
8 * Depending on model and options