Lukas LAA Pulling Device User Manual
Page 5
5
Move the arresting lever backwards until it latches in the end position.
8400
Insert the pulling rope into the pulling cylinder and push it through until the first sleeve
becomes visible at the trumpet-shaped tube.
8500
Latch the arresting mechanism again (reverse the sequence as described und item 8300).
Make sure that both arresting lever and spring-loaded pin properly lock in their end positions.
8600
Connect the two holding ropes with the attachment on the pullling cylinder as follows (see
fig. 3):
Remove the securing pin (3a) on one end of the fixing bolt and take the bolt out. Insert the fixing
eye (3b) of the pulling rope into the attachment and arrest the eye by means of the fixing bolt (3c).
Fix the fixing bolt with the securing pin again so that it cannot slide out.
fig. 2
trumpet
3a
3b
3c
fig. 3