Anchor MESH POOL COVER - Manual (Page 6)

6
STEP 2
:
PREPARE POOL FOR INSTALLATION
1) It is best to have water at operating level to install pool cover. Do not lower water more than
15” below deck level.
2) Remove all handrails, ladders, etc.
3) Unfold cover onto deck. DO NOT DRAG THE COVER.
4) Position buckets (filled with water) around pool.
STEP 3
:
PLACING COVER OVER POOL
1) Place bundled cover as shown.
2) Unroll pool cover at end of pool as illustrated below. (Cross webs should be on bottom side.)
3) Position a water bucket on web strap at center cross web.
4) Once cover is unrolled, start unfolding cover towards opposite end and place water buckets on a
web strap across from each other. Continue doing this until pool cover has completely covered
pool.
NOTE: Do not place water buckets on cover, damage may occur. Place water buckets
only on web straps.
BUNDLE
PLACED AT
END OF POOL
DECK
BUCKET
(TYP.)
UNFOLD
TOWARD THIS
END OF POOL
COVER
IMPORTANT NOTE:
Installation of pool cover must begin at
any areas with cut-outs or zero tolerance
areas (such as at cable-construction).
When there are several areas like this,
start at most complicated of these areas.
DECK
SPA
BUCKET
(TYPICAL)
SPA
SPA
BUCKET ON
STRAP
DECK