Lenze ECSCExxx Power supply module User Manual
Ä.l÷>ä
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- ECSxE - Power supply module
- This documentation is valid for ...
- !
- Scope of supply
- Connections and interfaces
- Status displays
- Contents
- 1 Preface and general information
- 2 Safety instructions
- 3 Technical data
- 4 Mechanical installation
- 5 Electrical installation
- 6 Commissioning
- 7 Parameter setting
- 8 Configuring system bus (CAN)
- 8.1 Setting the CAN node address and baud rate
- 8.2 Individual addressing
- 8.3 Determining the boot-up master for the drive system
- 8.4 Setting the mode for process data transfer
- 8.5 Setting the boot-up time/cycle time
- 8.6 Node guarding
- 8.7 Executing a reset node
- 8.8 Assignment of the control word
- 8.9 Assignment of status words
- 8.10 Diagnostics codes
- 9 Monitoring functions
- 9.1 Fault responses
- 9.2 Overview of monitoring functions
- 9.3 Configuring monitoring functions
- 9.3.1 Mains monitoring (LP0, LP1)
- 9.3.2 Voltage supply monitoring - control electronics (U15)
- 9.3.3 DC bus monitoring (OU, OC1, OC2, OC3)
- 9.3.4 Temperature monitoring of device heatsink (OH) / inside the device (OH1)
- 9.3.5 Fan monitoring (FAN1)
- 9.3.6 Brake resistor monitoring (OC6, OH3)
- 9.3.7 Brake chopper IGBT monitoring (OC4)
- 9.3.8 Device utilisation / I x t monitoring (OC5)
- 9.3.9 Communication monitoring (CE1 ... CE4, node guarding)
- 10 Diagnostics
- 11 Troubleshooting and fault elimination
- 12 Appendix
- 13 Index