Victorio VKP1024A Deluxe Grain Mill - Manual (Page 19)

17
MOTOR TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
I cannot attach the motor. Review p. 14 on how to attach the
motor, including how to correctly
align the motor shaft with the grain
mill shaft.
I cannot remove the motor. Sometimes the motor shaft can
get stuck or be difficult to remove.
Read all the Removal Steps on p.
15.
The motor is working but no grain
is going through the mill.
Sometimes grain can get stuck
and will not flow into the grinding
chamber. Gently tap the side
of the grain mill, just below the
hopper, using the side of your fist
or heel of your hand. This will
loosen the grains and help them
flow into the grinding chamber.
Grain is going through, but the
grain mill is producing very little or
no flour.
Carefully follow the Use
Instructions on p. 7 and make
certain, after you tighten the
adjustment knob, you turn it
back at least 1/4 turn. An overly-
tightened adjustment knob can
damage the milling cone, especially
while using the motor.
The motor does not turn on. Review the instructions and
diagram on p. 13 about the Power
Switch and the Overload Breaker.
The motor does not turn on and
the overload switch is not tripped.
Make sure the cord is plugged into
a live power outlet. Review the
diagram on p. 13 about the Power
Switch. Make sure the switch on
your motor matches the diagram
for the on, (“I”) position.