Audio Developments AD114 - Manual (Page 2)

1
INTRODUCTION
Unpacking
If there are any signs of damage to the outside of the carton, please notify us or your
supplier immediately, regardless of the unit's apparent physical condition. This is in
case a claim has to be made at a later date because of previously undetected transit
damage. The packaging material should not be discarded until the mixer has been
acceptance tested and a suitable transit/storage case is available for secure, safe
storage.
Visual Inspection
Identification - please make a separate note of the serial number for your own capital
equipment records. Ensure that it agrees with the number on the invoice/packing
note. The serial number label is on the back cover, adjacent to the battery
compartment.
Temperature - check the meter glasses for condensation. If the package has been
in transit during cold weather, leave the mixer for at least 12 hours to allow it to return
to normal room temperature. Any measurements or subjective tests then made, will
be to a known temperature reference.
Specific Points
Battery compartment - the mixer has an integral battery compartment to accept
6size-AA cells, and is built into the transversal extrusion.
DC-DC converter - is mounted on the right hand module. Care must be taken when
removing the module, because some wire looms connect from the module to the
base boards.
In order to facilitate the testing and calibration of all modules, a set of two extender
modules is available from the factory.
Connectors - for convenience, the connector panel is labelled for reading from
above. All connectors are in line with their corresponding module.