Capital Cooking GSCR484G - Manual (Page 38)


NOTE: NO air shutter adjustment is necessary or
possible with the sealed top burners.
NOTE: If the sealed burners do not ignite and
there is NO clicking sound, turn OFF the gas and
check for tripped circuit breakers, blown fuse or
wire connection to the igniter.
INSTALLER CHECKLIST
FINAL CHECKLIST
q
Placement of unit
q Specified clearances maintained to cabinet surfaces
q Unit Level – front to back – side to side
q Burner caps positioned properly on sealed burner bases
q All packing materials removed
q Island trim or back guard attached (if horizontal
clearance to combustible materials behind
cooking surface is less than 12”)
q
Check door adjustment and hold down brackets
GAS SUPPLY
q
Connection: 1/2” NPT with a minimum of 5/8”
diameter flex line
q The appliance is connected only to the type of gas
for which it is certified for use
q Manual gas shut-off valve installed in an accessible
location (without requiring removal of range)
q Unit tested and free of gas leaks
q Gas supply pressure does not exceed 14” (37 mb) W.C.
ELECTRICAL
q
Receptacle with correct over current protection is
provided for service cord connection
q Proper ground connection
q Proper polarity at receptacle
q Kick panel in place and 3 screws secure.
OPERATION
q
All internal packing materials removed. Check
below grates and grill pans and within ovens
q If used on Propane gas, verify that the propane
gas supply is equipped with its own high-pressure
regulator in addition to the pressure regulator
supplied with appliance.
q Burner caps properly seated into burner bases.
q Grill Components properly seated (not all models).
q Bezels centered on burner knobs and knobs turn freely.
q Each burner lights satisfactorily, both individually
and with other burners operating
q Air shutter adjustment for proper flame made for
Grill and Griddle sections.
q Griddle is level and does not rock.
q Oven door hinges seated and hinge locks in proper
position. Door opens and closes properly.
q Burner grates correctly positioned, level and do
not rock.
Note to Customer:
Please make sure installer signs each item on this
checklist, explains each item before leaving.
P O S T - I N S T A L L C H E C K