Dyras ESI-2000AC - Manual (Page 5)

ESI-2000AC
8
EN
ESI-2000AC
9
Always keep the soleplate clean. Avoid storing the iron in a dusty or greasy
environment and prevent metallic objects (e.g. ironing board mechanism, zips,
metal buttons etc) from scratching the soleplate. Take care to use the appropriate
temperature when ironing certain fabrics. Using an inappropriately high temperature
can cause some material (particularly synthetic fabrics) to burn onto the soleplate.
The manufacturer is not liable for damage caused by a failure to follow the operating instructions
(e.g. burning fabric onto the soleplate or damaging the soleplate by using abrasives when
cleaning it).
Fabrics made from 100% wool can be ironed using the steam setting.
However, you are recommended to use a clean, plain cloth between the iron and the fabric.
Setting the correct temperature:
1. Always check whether there are ironing instructions for your chosen clothes or fabric.
These instructions must be followed. Temperature settings are usually indicated by an iron symbol
containing one, two or three dots.
2. If there are no ironing instructions but you know what fabric the clothing is made from, please follow the
instructions in the table overleaf.
3. If your clothing is made from a combination of different materials (‘mixed fibres’), set the iron temperature
for the part that requires the lowest temperature.
4. Before you start ironing, sort your clothes according to the different heat settings required (e.g. all wool
clothes together, all cotton together, etc).
5. Start your ironing by setting the temperature dial to the lowest setting and selecting clothes that require the
lowest temperature (e.g. synthetic fabrics). Next, continue with fabrics requiring a higher temperature (e.g.
wool, cotton, linen).
6. Turning the temperature dial in a clockwise direction will increase the temperature of the soleplate.
MAIN COMPONENTS
1. Soleplate
2. Steam nozzles
3. Control dial for temperature and fabric
4. Self-clean button
5. Water tank
6. Handle
7. Water spray
8. Water fill and drain cover
9. Steam control
10. Button for extra burst of steam
11. Water spray button
12. Heating indicator light
13. Upper cover
14. Cable support
15. Heel rest (rear cover)
16. Power cable with plug (not shown)
POWER SUPPLY
The appliance should only be connected to 230V~ 50Hz electrical mains with a protective earth
connection. Always verify that the mains voltage at the place of use is the same as the voltage
indicated in the rating label on the appliance.
USING THE APPLIANCE
Before using the iron:
1. Unpack the iron and remove all packaging materials. Carefully check the appliance to ensure it is complete
and undamaged. Some elements of the iron were covered in a thin layer of oil during manufacturing; this
may result in a small amount of smoke when the iron is first used but will soon stop.
2. When the iron is first switched on, wipe the soleplate on an old piece of cloth to make sure the soleplate
and water tank are both clean. The sole plate is made from stainless steel on an aluminium base, which is a
long-lasting combination that resists damage and scratches.
9 8
User'sManual for ESI-2000AC.indd 8-9 User'sManual for ESI-2000AC.indd 8-9 2010.12.09. 14:53:48 2010.12.09. 14:53:48
Process Black Process Black