Dyras ESI-2000AC - Manual (Page 8)

ESI-2000AC
14
EN
ESI-2000AC
15
Failure
Fabric becomes shiny after ironing;
fabric shrinks and burns during
ironing
No steam or water is being
released from the appliance
Insufficient steam is being generated
Water is dripping from the soleplate
Steam volume is insufficient and is
released unevenly from the outlet
nozzles
There is no water spray
Possible cause
Soleplate temperature
is set too high
The water tank has
not been filled correctly
The temperature control dial may
not be set to the ‘steam’ zone
The steam control may be closed
There is no or little water in the
water tank
The appliance hasn’t heated up
enough to generate steam
The extra steam burst button has
been pressed too frequently
The water tank has been overfilled
The steam nozzles or water tank are
blocked
There isn’t enough water in the tank
There isn’t enough water or air
pressure
There isn’t enough water in the tank
Solution
Turn temperature control
dial to the correct position
Refill the water tank
according to the instructions
Set the temperature control
dial to the appropriate steam-
generating position
Push the steam control knob to
release a higher volume of steam
Fill the water tank
Wait until the heating indicator lamp
switches off before pressing the
steam burst button
Don’t use the steam burst function
more than three times in any
heating/cooling period. (Wait for the
light to switch on and then off). Wait
for longer between steam bursts
Pour excess water from the tank until
it is at the horizontal MAX marking
Activate the self-cleaning function.
If you find you need to do this
frequently, start using distilled water
instead of tap water
Fill the water tank
Cover the water spray nozzle with
your hand and press the water spray
button several times
Fill the water tank
15
Cleaning the soleplate
To remove dirt and textile fibres from the soleplate, use a soft cloth soaked in a gentle non-abrasive detergent.
Wipe the soleplate with this cloth, then wipe it with a damp cloth. Never use abrasive cleaning agents or metallic
scourers as these can damage the surface of the soleplate.
Note: the glossy surface of the soleplate can become slightly worn with use, particularly if used frequently or for
ironing rougher fabrics. This will not affect the operation or performance of the appliance.
Cleaning the body of the iron
1. Clean the outside cover of the appliance with a damp, soft, lint-free cloth and then wipe the cleaned
surfaces with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the appliance dry
completely before re-using or storing it.
2. Never use solvents (acetone, benzene, petrol etc.) to clean the appliance because these materials could
dissolve the plastic cover and damage the internal components. Do not use harsh or abrasive cleaning agents.
3. Before storing the iron, empty the water tank and leave the fill/drain cover open until the tank is completely
dry. Any moisture could cause mould.
4. Never remove the casing or dismantle the iron.
5. The iron should only be packed away for storage when it is completely cool and has been cleaned. If you do
not plan to use the appliance for a while, put it in a plastic bag and store it in a dry, dust-free and frost-free
place. Never leave any water in the tank.
14
User'sManual for ESI-2000AC.indd 14-15 User'sManual for ESI-2000AC.indd 14-15 2010.12.09. 14:53:48 2010.12.09. 14:53:48
Process Black Process Black