Vetter Struts and Accessories - Manual (Page 12)

Page 12/24
AIRSHORE Struts and Accessories for Rescue
Should you be using extensions, please note the following:
Important information!
A maximum of just one extension can be used per
strut!
For struts AA, A, B, C, D only
one extension each up to ART-E24
can be used!
For struts ART-E and -F only
one extension each up to ART-E72
can be used!
Extensions ART-E36, E48 and E72 may only be
attached to the lower end of the strut and not the
top!
4.3 Dismantling
Manually:
Loosen the T-grips and move the sleeve down according to the spiral
turn, so that the safety pins are released. Pull the safety pins out and
slide the piston into the support tube. The components can be stored
after dismantling and cleaning of the attachments.
Pneumatically:
Apply the permissible positive air pressure to the strut with the filling
hose and the control mechanism. When the safety pins have been
released, the sleeve can be moved according to the direction of the
spiral. Pull the safety pins out and slide the piston into the support
tube. The components can be stored after dismantling and cleaning
of the attachment elements.
Safety must be observed when storing and
transporting to avoid damage to loose
components!
Information on transport security:
Locking the sleeve with a safety pin (drill hole in the sleeve)
arrests the piston and the sleeve for transport or storage.