Allen&Heath Qu-32 - Manual (Page 68)

Qu Mixer User Guide 68 AP9372 iss.5
11.2 System Hard Reset
A power up reset is available if you need to fully reset
the Qu mixer settings and memories. This could be
done to clear the system out before sending the mixer
to a client, or if you suspect a system problem.
To reset mix parameters before starting a show or
sound check, use a Scene or the Reset Mix Setting
function described earlier in this guide.
Note – A hard reset clears all current settings, all
Scenes, User Libraries and User Permissions.
First turn off the system including amplifiers and
powered speakers.
To hard reset the Qu mixer - Press and hold the
touch screen Reset and Setup keys together and then
power up the mixer. Keep the keys pressed for at least
5 seconds while the mixer boots. Release the keys.
The hard reset:

Resets the current settings the same as using the
Scenes screen ‘Reset Mix Settings’ button.

Resets non-scene parameters and user
preferences to a factory default.

Clears scene recall Safes and Filters.

Clears all memories including Scenes, User
Libraries and User Permissions.

Resets the Network IP address and the touch
screen calibration.
System hard reset:
 ‘Reset Mix Settings’ default as above

Input PAFL = PFL, mix = AFL

PAFL additive mode off

Sel follow PAFL on, LR to PAFL on

PAFL trim 0dB, delay 0ms

Talkback mic gain 27dB

Sig Gen Pink Noise, unassigned
 Clears all scene Safes

Clears all Scene memories

Clears all Scene Filters

Clears all User Libraries

Resets all User Permissions

Resets Network address to DHCP

Resets touch screen calibration
Hold for 5 seconds
while powering up
the mixer