COMEUP Compact Winch (Ver:00) - Manual (Page 13)

11
Braking
● Braking device is composed of a mechanic brake and an electronic generated brake. The
brake distance from the time of braking until stopping completely should be within 1.5% of rope
length to the wound in during 1 minute.
● Owing to the rope speed on no load is 1.5 – 1.8 times faster than that on rated load, the brake
distance on no load will be longer, but still within 1.5% of rope length.
● It is highly recommended that any adjustments are carried out by a qualified technician at an
authorized service centre.
● Brake adjustment procedures
Step1. Remove retaining ring and spring pin
Step2. Tighten 1st gear/2nd shaft for CWL-80 or 3rd gear /4th shaft for CWL-200/200L/301/301L
counter-clockwise until holding to the ratchet
Step3. Find the closed pole between spring pins and fit plate (one between four selections),
then put the fix plate onto the square hole of 3rd or 4th shaft.
Step4. Insert spring pins and lock retaining ring.
Oil Replacement
Gear lubrication is an important component in insuring the long life of your winch. Winch are
pre-lubricated at the factory and do not require initial lubrication. Re-lubrication interval depends
upon service, 250 working hours of a year, or after repair or disassembly. Consult your local
lubricant distributor on the selection that best fits your climate and application.
Gear Oil Quantity
Intervals
NIGI No.0 CWL-80 CWL-200 CWL-200L CWL-301 CWL-301L
Caltex Multifak EP
100 cc 300 cc 300 cc 300 cc 300 cc
Cosmogear SP460
fix plate
spring pin
2nd / 4th shaft
ratchet
1st / 3rd gear
1 Year or
250
working hours