IC Realtime Villa Outdoor Station (IHC6260) - Manual (Page 9)

I C R E A L T I M E S E C U R I T Y S O L U T I O N S
2.b Step by Step Guide

Note: Reference the labeled table below for screw type
 Step 1: Remove front plate cover
Begin by taking off the front plate of the camera. There will be one (1) small screw (a) at the bottom of
the lip of the camera. The plate should pop off.
 Step 2: Cut out hole in wall
You will need to trace out a box at the installation point so the back end with your connections fit flush
to the wall. You may use a gang box conceal the surrounding connections.
 Step 3: Test fitting and fasten to wall
Assure the camera fits flush to the wall and aligns with your installation points. Use the included anchors (d)
to install in the wall. Use the two (2) screws (b) to fasten from the two holes by the cameras lens in to the wall.
 Step 4: Replace dome cover
Lastly, make sure the camera is well placed and it firmly tightened to the wall. Replace the front plate and
use the one (1) small screw (a) to attach back to the body of the camera
Screw Notes
No. Name Illustration
a M3×8 Cross recessed countersunk head-black zinc
b M4×30 Cross recessed pan head screws
c ST3×18 Cross recessed pan head tapping screws –white alloy
d Expansion pipe ￠6*30mm white
6