Jaypro Sports PBEL96 - Manual (Page 12)

ELITE Series Adjustable Portable Backstop Instructions
- 8 of 27-
JSL-Inst039
www.jayprosports.com
Figure 6-3: Install backboard support arms to slots in boom.
3. Support backboard such that the mounting holes in the bottom
middle of frame are in line with the bolt pattern on the end of the
boom (Figure 6-4). Sawhorses or a forklift may be used if additional
hands are not available to help.
Figure 6-4: Backstop boom.
4. Insert 3/8”-16 x 1½” hex bolts (2X), 3/8” flat washers (2X), and 3/8”
split washers (2X) into middle row of holes in backboard mount
(Figure 6-5, details A & B).
5. Slide the bolts in step 4 into the middle set of holes of the backstop
boom. Fasten bolts to boom using the 3/8” flat washers (2X) and
the 3/8” flanged nuts. Hand-tighten the nuts.
6. Attach the backboard support arms to the slots in the top of the
backboard frame using the 3/8”-16 x 1¼” carriage bolts (2X), 3/8’
split washers (2X), 3/8” flat washers (4X), and 3/8” flanged nuts (2X)
as shown in Figure 6-5 (detail C). Hand-tighten the nuts.
7. Check the plumb and of the backboard. If it is not plumb, slide the
backboard support arms in the slots in the boom until the board is
plumb. Once the board is plumb, wrench-tighten all nuts.