Keri Systems HPP-100 - Manual (Page 10)

HPP-100 Hand-Held Programmer
Revision 3.3 4
The Master Control Reader’s LED
The Master Control Reader’s LED can be used to identify the Master Control Unit’s current status.
The Master Control Reader’s LED
Single Quick Flash confirms an access card was read during normal operation
Fast Blinking indicates the Master Control Unit is in the programming mode
Slow Blinking indicates the Master Control Unit is set to the enrollment mode (for PC
operation only)
The Personal Identification Number (PIN)
A Personal Identification Number (PIN) is assigned to provide security for the Hand-Held
Programmer. A user must enter the correct PIN before the Master Control Unit will enter the
programming mode. A default PIN is assigned at the factory; the default PIN is [0] [0] [0] [0].
We recommend that you set a unique PIN as soon as possible to ensure the security of your PXL-
100 access control system.
Using the PIN to Enter Programming Mode
To enter the programming mode, point the Hand-Held Programmer within 3 to 5 inches of the
Master Control Reader and enter the PIN number. The very first time programming mode is
entered, the PIN will be the factory default PIN: [0] [0] [0] [0]. If the PIN is accepted, the Master
Control Reader’s LED will pulse quickly indicating commands can now be programmed into the
Master Control Unit. The optional LCD (if installed) will display the following information, indicating
the Master Control Unit is ready to accept commands.
[h] COMMAND [1]
ENTER OPTION
If the PIN is not accepted, the Master Control Reader’s LED will not pulse and the reader will
respond with a command rejected ‘NO-BEEP.’ Press the CLEAR key and repeat the command. If
the PIN is still not accepted, this may mean the PIN has been changed and will need to be reset.
Instructions for resetting the PIN can be obtained from Keri Systems. Please contact Customer
Support for this information.