Luma Comfort MF24B Manual - Manual (Page 6)

6
www.LumaComfort.com
A
SSEMBLY
I
NSTRUCTIONS
It is strongly recommended that a second person be available to assist
during the assembly process.
DO NOT plug in the fan before assembly. This misting fan comes in two
separate boxes. Carefully remove all packaging materials and retain for future
storage/use. Make sure there is no residual foam left in any of the components.
A screwdriver and wrench will be required to assemble this misting fan.
S
TEP
1: A
SSEMBLING THE
S
TAND
P
OLE
1. Refer to diagram 1 below. Remove the following parts from the fan’s base
and set them aside: four (4) M6x16 screws, large washers, small washers,
and nuts.
2. Place the stand pole on the fan base, align the screw holes and secure the
pole in place using the screws, washers and nuts. Make sure the hole
located near the bottom of the stand pole is facing the square shaped
pump slot.