Luma Comfort HCW10B - Manual (Page 10)

10
www.LumaComfort.com
T
IMER
F
UNCTION
1. Press the “S” button twice so that the “H” indicator light turns on in the
control panel. This sets the timer function. Use the “+” and “-“ keys to set
the timer’s duration. The timer can be set from 1 to 12 hours. After your
time has been set, wait for 5 seconds and do not press any other key.
2. The display will revert back to the humidity level but will alternate
between showing the humidity level and the set time.
O
PERATING
T
IPS

Run the unit on the lowest setting to extend running time.

Set the humidistat at your desired humidity level. This will turn the unit on
and off as needed and extend the running time.

When filling the tank, fill it up completely and then place it on the base.
Let the water empty into the base until it stops bubbling, then refill the
tank again. This ensures maximum water capacity and will also extend run
time. The Luma Comfort HCW10B will run up to 40 hours without
interruption, depending on room conditions.

This humidifier operates with a demineralization cartridge that makes it
capable of operating with any kind of water. However, using distilled
water in your humidifier will keep it running in optimum condition for a
longer period of time. It will also make easier to clean your humidifier, and
eliminate white dust.

Only operate your humidifier in areas where the relative humidity is lower
than 50 percent. Higher humidity levels will encourage the growth of
bacteria and other biological organism.