Vizualogic SmartView Full 360 - Manual (Page 6)

5 | Wire Harness Connections/Installation www.vizualogic.com
Wire Harness Connections
Installation
The SmartView™ wire harness has 7 wires which connect to the
vehicle’s existing wire system. The wires have corresponding tags on
them to know which wires to connect them to.
• RED - +12ACC (Accessory Power)
• BLACK - Ground
• WHITE - Left Control (Signal)
• BLUE - Right Control (Signal)
• GREEN - N/A
• YELLOW - Reverse Control
• ORANGE - Reverse Transfer Wire (For Aftermarket Double Din Stereo)
STEP 1 - Make sure front windows are down. Remove side mirrors and
interior side mirror cover. Install the side cameras through them. Cameras
should be mounted underneath the side mirror, close to where the side
mirror housing touches the side of the vehicle. Be sure to leave a little slack
from the cameras’ wire’s to adjust the viewpoint once connected to the
monitor. Remove door panels and any other parts in order to get to the
vehicle’s grommets to run the wires through into the inside of the vehicle.
STEP 2 - Next, open the trunk and remove the lining that is connected to
the trunk’s lid. Install rear camera. Use screws provided.
(Optional: You can have the rear camera flush-mounted by using the
hole saw screw and plastic with metal open-end caps.) Run rear camera
wire along existing wires of trunk and into the back seats. If vehicle is not
equipped with drop-drown back seats, you will have to remove back seats.
Remove door sill plates and run rear camera wire along side of vehicle.