Vizualogic SmartView Full 360 - Manual (Page 7)

Installation (cont.)
STEP 3 - For the front camera installation, mount camera in a suitable area
in the front of the vehicle. Use screws provided. Run front camera wire
under hood along existing vehicle wires and into the firewall of the vehicle.
STEP 4 - Locate the vehicle’s wires for turn signals, reverse, hazards, etc.
Connect wire harness to the corresponding wires of vehicle. Remove
center dash console and run vehicle wires attached to wire harness in
the center dash area. Run all camera wires to the center dash area as
well. Connect wire harness to control box and the camera wires to the
corresponding inputs (F=Front, B=Back, L=Left, R=Right). Connect the
RCA Video cable as well to the control box and to the vehicle’s monitor.
Note: The SmartView™ remote control is used for vehicle’s that have a
separate monitor that is always on whenever the vehicle is on. Remote
control will not work with a double din stereo.
STEP 5 - After connecting all wires to the control box and the RCA Video
cable to the vehicle’s monitor, test the system and adjust the cameras
positions. Side mirror cameras should be in the viewpoint of the driver’s
blind spots.
Installation | 6 www.vizualogic.com