Danby DBD5L - Manual (Page 20)

Problem Possible Causes What To Do
1)The beverage
dispenser is not
cooling
2) Beer or beverage
is not being
dispensed
3)The dispenser
temperatre display
is not illuminated
4) Excessive foam,
spilling, or spraying
occurs
5) The dispenser is
1) No power supply
1a) Low voltage
1b) Blown fuse
2) The mini keg or
container is empty.
2a) The DISPENSING or
AIR-CONNECT TUBE is
pinched.
2b)The air pressure switch
is in the AIR OFF position.
2c) Air is leaking.
3) No power
3a) The power switch
remains in the OFF (O)
position.
4) First glass
4a) The mini keg is not
cold enough, or has been
shaken.
4b) The DISPENSING
TUBE or AIR-CONNECT
TUBE is leaking, or the
ADAPTOR is not prop-
erly sealed.
4c) Dispensing tap is not
open enough
5) The air pressure is
1) Make sure the dispenser is plugged into a 3 prong
outlet
1a) Make sure the dispenser is plugged into a proper
120V outlet
1b) Change fuse. It is recommended that a qualified
electrician change the fuse on the dispenser
2) Change the keg or container.
2a) Make sure the TUBES are not kinked when
connected. If necessary, turn the keg in the dispenser
to even out the TUBES.
2b) Switch the air pressure to the AIR ON position
2c) Make sure there is an air-tight seal between the
keg and the RISING PIPE. Also, make sure the
CONNECTORS and TUBES are properly attached and
secured. If necessary, change the TUBES.
3) Make sure the dispenser is plugged into a 3 prong
outlet.
3a) Push the power switch to the ON (
l
) position.
4) The first glass from a keg can have too much foam.
This is normal.
4a) Always pre-chill the mini keg before tapping, and
store keg where there is little or no movement for at
least 24 hours before using to allow for chilling and
rest.
4b) Make sure the TUBES are properly connected. If
necessary, change the TUBES. Make sure the
ADAPTER is securely fastened to the mini keg. If
necessary, re-connect.
4c) Pull the tap handle completely down to ensure the
tap opens up.
5) The air pressure switch is turned to the ON
position.This is normal. If not in use, turn to the OFF
position.
BEFORE YOU CALL FOR SERVICE
TROUBLE SHOOTING
making a humming
noise
turned off
20