Cino M230B - Manual (Page 6)

Verify Micro2 is Working
After fully charging the battery pack and loading the receipt roll, you can
print a configuration message to verify Micro2 is in proper working condition.
A configuration message will be printed after executing the self-test
procedure.
Steps:
1. Make sure the Micro2 is power off.
2. Press and hold the FEED Button and then press POWER Button.
3. Release both POWER and FEED buttons. The LED1-4 will flash 5 times
to indicate the battery status firstly, then the LED1 gives short orange
blinks 10 times. The Micro2 will start printing a configuration message.
4. Pull one edge of the receipt paper against the tear bar to tear the
configuration message down.
This message provides information on firmware version, communications,
power management, printer control setting, general specifications head
resistance and odometer.
Using Your Micro2
Connecting the Printer Via Bluetooth
Please refer to the VersaJet Micro2 User’s Guide on the Internet at
www.cino.com.tw for establishing Bluetooth connection.
Connecting the Printer Via RS232
Host Interface Connector
1. Plug the connector of the RS232 cable into the Host Interface Connector
of the printer.
2. Power on the printer. The LED1-4 will flash 5 times to indicate the battery
status. Then the LED1 indicator will flash green at 2 seconds intervals.
3. The printer is now ready to print.
5