Cino M230B - Manual (Page 9)

Warning and Error Messages
LED1 LED2 LED3 LED4 Description
Orange Green
Start blinking after steady on for 10 seconds
Paper jam (*1), or
Label length measurement error (*2)
Orange Green Green
Start blinking after steady on for 10 seconds
Media compartment cover opened (*3)
Orange Green Green Green
Start blinking after steady on for 10 seconds
No Paper (*4)
Orange Green Green Orange
Start blinking after steady on for 0.5 seconds
Command Error (*5)
Orange Orange
Start blinking after steady on for 10 seconds
Motor over cooled (*6)
Orange Red
Start blinking after steady on for 10 seconds
Motor over heated (*7)
Orange Orange Orange
Start blinking after steady on for 10 seconds
Print head overcooled (*6)
Orange Orange Red
Start blinking after steady on for 10 seconds
Print head overheated (*7)
Red Red
Start blinking after steady on for 10 seconds
Print head broken (*8)
(*) Please refer to the following resolutions.
1. Paper Jam:
 Open the media compartment cover and reload the media roll.
2. Label Length Measurement Error:
 Check whether the sensor type and media type are correct.
 Re-conduct paper length measurement.
3. Media Compartment Cover Opened:
 Close the media compartment cover.
4. No Paper:
 Load the media roll.
5. Command error:
 Reset Micro2.
 Resend a correct command.
6. Print Head or Motor Overcooled:
 The printer will automatically resume operation after the print head or
motor comes to the normal temperature.
7. Print Head or Motor overheated:
 The printer will automatically resume operation after the print head or
motor cools down to the normal temperature.
8. Print Head Broken:
 Call a qualified service technician to replace the print head.
8