DaySequerra iLC2ST User Manual
Page 28
28
iLC2ST User Manual
LIGHT PRESET - This preset is designed for very
subtle loudness correction over longer periods of time.
It characteristically has a lower Loudness Correction
Ratio and a slower Attack and Release time. The
secondary Compressor is set further away from the
Target as to allow more transients. The goal of this
preset is to fine-tune long-term loudness levels while
preserving a majority of the original signal’s dynamic
range.
MEDIUM PRESET - Medium preset has higher Ratios
but slower release times. This allows for full correction
to be applied but overcomes a ‘nervous’ or ‘jumpy’
sound of fast processing. The secondary Compressor
is set further away from the Target as to allow more
transients. The goal of this preset is to achieve a
consistent output while preserving some of the original
dynamics of the input signal.
AGGRESSIVE PRESET – The Aggressive preset has
1:1 Ratios and short Attack / Release times. The
secondary Compressor is set close to the target to
reduce transients. Frequency compensation has been
turned off to allow equal spectral gain to be applied to
the lowest of input signals. The goal of this preset is to
achieve very consistent outputs with limited dynamic
range.
Parameter
Default
Correction Ratio
0.95
Upper Threshold
0 dB
Lower Threshold
0 dB
Dead Band
4.0 dB
Noise Floor
-55.0 LKFS
Attack/Rise
50 ms
Release/Fall
220 ms
Frequency Shaping
0
Compressor Threshold
5.0 dB
Compressor Ration
0.5 dB
NLC Measure
NLM
Stereo Target Level
-24 dB
Parameter
Default
Correction Ratio
0.98
Upper Threshold
0 dB
Lower Threshold
0 dB
Dead Band
2.0 dB
Noise Floor
-55.0 LKFS
Attack/Rise
50 ms
Release/Fall
150 ms
Frequency Shaping
0
Compressor Threshold
5.0 dB
Compressor Ration
0.5 dB
NLC Measure
NLM
Stereo Target Level
-24 dB
Parameter
Default
Correction Ratio
0.01
Upper Threshold
0 dB
Lower Threshold
0 dB
Dead Band
1.0 dB
Noise Floor
-55.0 LKFS
Attack/Rise
50 ms
Release/Fall
100 ms
Frequency Shaping
0
Compressor Threshold
5.0 dB
Compressor Ration
0.5 dB
NLC Measure
NLM
Stereo Target Level
-24 dB