Dv Mark MULTIAMP MIDI PEDALBOARD - Manual (Page 5)

5
pROGRAM cHANGe
> NORMAL MODE (8 PC footswitches)
The MULTIAMP MIDI PEDALBOARD starts in PROGRAM CHANGE (PC) mode when you power it, allowing to recall 8 different presets
pressing the 8 switches of the pedalboard (red light shows the switch number in use and the program change number appears on the display
when you press the switch).
You can assign a specific preset to a program change on your Multiamp or on your MULTIAMP MIDI PEDALBOARD .
- Multiamp: To map MIDI program numbers to specific presets of the Multiamp go to the PRESET/PATCH MAP at SYSTEM>MIDI menu. The
number on the left of the display is the PATCH number sent via a MIDI Pedalboard/Controller (MIDI program number), use the UP/DOWN
buttons to select the number to be mapped to a preset. The number on the right of the display is the PRESET number to map, that will be
recalled when the MIDI program number on the left is sent, use the VALUE control to select the preset number to map to. Press ENTER to
save the MAP.
- MULTIAMP MIDI PEDALBOARD
Press the switch to which you like to assign a specific preset number, then press “OK” button.
“000” will appear on the display, use the +1/-1 (8/4), +10/-10 (3/7), +100/-100 (6/2) switches to select the desidered preset number, then press
OK and on the display will appear “Stored” to confirm that the preset number is assigned to the switch.
> INCREMENTAL MODE (6 PC footswitches and preset up/down)
It is possible to set the footswitches in INCREMENTAL MODE (INC), having the switches 8 and 4 to scroll presets UP and DOWN, and the
other 6 switches associated to specific preset numbers.
To set the Incremental Mode push the “MENU” button, then scroll the UP/DOWN switches (8-4) until “PCF” (program change format) will
appear on the display, then press “OK”.
Select the “Inc” mode with the UP/DOWN switches, press “OK” and then “ESC”.