Dv Mark MULTIAMP MIDI PEDALBOARD - Manual (Page 9)

9
MultIAMp MIDI peDAlBOARD MeNu
MAIN MENU (>) | SUB MENU (-)
> Chl (MIDI channel)
> FSt (factory restore)
- PAS (password: digit 163 then press OK)
- PrE (preset settings)
- SEt (reset device settings)
- ALL (reset all)
> InF (firmware info)
- F:x.x (firmware version)
> PEd (expression pedal)
- CHA (characteristic of the pedal)
- F-S pedal movement response (fast increases at the beginning, slow at the end)
- LIn (linear)
- S-F pedal movement response (slow increases at the beginning, fast at the end)
- UP (maxCC value send from controller) / “000” to “127”
- dO (min CC value send from the controller) / “000” to “127”
- CUr (actual value or noise, it can be changed using UP/DOWN switches)
- OUT (displays the expression pedal value sent to the MIDI OUT, pedal status must be ON)
- NOISE” check the hum level of the pedal connected to the exp pedal input
- CAL (calibration)
- SETPdo (set the pedal to DOWN position) / “000” to “127”
- SETPuP (set the pedal to UP position)”000”...”127”
> PCF (program change format)
- nor (normal mode)
- bAn (bank mode)
- Inc (incremental mode)