LG Motorsports LG C6 Carbon ZR1 Splitter - Manual (Page 2)

Instructions:
Prep:
Un-pack all of your items and inspect for any damage. Be sure to report anything wrong
as soon as you receive your package.
Figure 1: Unpack
Start your install by supporting the car with 4 jack stands on a level surface about 12” or
more off of the ground. Take some time to wash the area that the splitter is going on, as
you do not want to trap any dirt or debris between it and the paint of the car.
Figure 2: Support and Clean
Once the car is supported and you have washed the area clean you will need to remove
the factory front splitter piece by using a 7mm nut driver. Be sure to save these as you
will need to use them to start the install of the new carbon piece.