LINK Systems OmniLink II Press Automation Control - Manual (Page 53)

August 30, 2002 Manual Version 1.0 4.4
Pressing the NEXT PAGE softkey causes the second page of the Device Configuration menu to be
displayed, as shown in Figure 4.3.
Figure 4.3 Device Configuration Menu, Second Page.
The OmniLink II Press Automation Control provides for up to 5 Die Protection and Process Monitoring
Modules, each with either 8 or 16 inputs. Before toggling a Die Protection and Process Monitoring
Module to a “Used” setting of Yes, you must assign each module a module number. This is done by
opening the door of each module and setting a rotary switch in the module you wish to designate as
module 1 to the number 1. For each module used, set a different successive number on the rotary switch
that indicates module number. When you have finished, an LED number display in the front door of
each module indicates module number when power is on. Once you have assigned a module number to
each die protection module to be used with the system, toggle to Yes for the “Used” setting for each
module number used.
Section 4.2 The Main Configuration Menu
The Main Configuration Menu is used to configure:
1. Settings based on the characteristics of the press upon which the OmniLink is installed. Brake
Monitor Stop Time Limits, Clutch Engagement Time Limit, and stroke length are examples of
settings that depend on the individual press.
2. Settings for Encoder Offset, Auto Top Stop Compensation, Top of Stroke Angle
3. Choices of what you wish to show on areas of the Operator Terminal Display in certain areas
reserved for user customization.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
SYSTEM STATUS
Counter OFF
0 0
OK
TOP
Device
Config
TOGGLE
USED
UPDATE
PROGRAM
EXIT
PREVIOUS
PAGE
Device Configuration
Device Used Status
Die Protection Module 1
Die Protection Module 2
Die Protection Module 3
Die Protection Module 4
Die Protection Module 5
Yes
No
No
No
No
Hardware Detected :
Hardware Version :
Bootcode Version :
Software Version :
Avail. Version :