Lumagen VisionProHDP - Manual (Page 39)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 36 Rev 1.1
Specifications
Inputs
Ten standard inputs: Two composite, two SVideo, two SD/HD component/RGB, two
DVI-D/HDCP inputs and two SDI inputs.
Composite, SVideo and component inputs support NTSC (M, Japan, 4.43), PAL (B, D,
G, H, I, M, N, Nc) and SECAM (B, D, G, K, K1, L).
Component input color-space can be selected as SDTV or HDTV.
Absolute maximum rating is ±2 volts, referenced to case ground, for analog video inputs.
Processing
Per-pixel motion adaptive deinterlacing and inverse-telecine for SD and HD sources.
Proprietary scaling algorithms provide detail-enhancement.
Adjustments for sizing, black-level, contrast, color, Hue, color/Hue offset, and Y/C delay.
11-point parametric grayscale and gamma calibration.
Source aspect ratio selection of 4:3, 4:3 nonlinear-stretch, letterbox, 16:9 and 1.85.
Supports two zoom steps for each source aspect ratio.
Four independent configuration memories per input.
Output
DVI-D/HDCP and analog outputs to 1920 by 1080 at up to 60 Hertz.
The analog output supports RGB and YP
R
P
B
. Both formats support bilevel and trilevel
sync. RGB also supports discrete horizontal and vertical, or discrete composite, sync
with programmable polarities.
YP
R
P
B
output color-space can be selected as SDTV or HDTV.
For red, green, blue and Luma, the nominal output is 1.0 volts peak-to-peak with
embedded sync, and 0.7 volts otherwise. For P
R
and P
B
, the peak-to-peak is 0.7 volts,
including sync. Output levels are specified driving an external 75-ohm load.
Discrete sync outputs drive TTL levels into an external 75 ohm load.
Eight independent output configuration memories are supported.
Resolution is programmable from 480p to 1080p in scanline increments, plus 1080i.
Vertical refresh rate is programmable from 48 to 120 Hertz in steps of 0.01 Hertz. This
varies with resolution.
Output aspect ratio is programmable from 1.33 to 2.35 in steps of 0.01.
Output size and position are programmable in pixel increments.
Miscellaneous
Menu based setup.
Infrared remote, or RS232 serial control interface.
Dimensions: 17” (W) by 10” (D) by 3.5” (H).
Power consumption: 25 watts nominal.
The power supply input rating is from 100 to 240 volts at 47 to 63 Hertz.
Silent operation (no fan).