Mighty Mule FM352 - Manual (Page 42)

38
M i g h t y M u l e 3 5 2
Step 3
Save the setting by pressing the transmitter and allowing the gates
to return to the fully closed position. YOUR OPEN POSITION LIMIT
IS NOW PROGRAMMED.
Step 4
Repeat step 2-3 for the other arm that has not been programmed
in step 2.
TESTING YOUR OPEN LIMIT SETTING:
Press your entry transmitter and allow your gate to open. If OPEN
position is not correct or needs to be changed you will need to
CLEAR your OPEN LIMIT (see below) setting and follow steps 1
through 3 again.
CLEARING PROGRAMMED OPEN LIMIT SETTING:
If you make a mistake and set the limit at the wrong position – press
your transmitter to return the gate to its fully closed position, then
press and hold the "SET LIMIT" button for the corresponding arm for
5 seconds. This will clear the memory for the open limit position.
Follow Steps 1-3 again.
1 ON
2
3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN BLK RED EXIT
SAFETY
EDGE CY
CLE
COMMON
LINK
SET LIMIT Button
MASTER CONTROL BOARD
SET LIMIT Button
SECOND CONTROL BOARD
15
STATUS
MIN MAX
STALL FORCE
SET
LIMIT
LINK