d&b Z5408 Horizontal bracket 8S - Manual (Page 5)

1.4. Mounting options and angle settings
Mounting holes are provided on the tie bar of the bracket.
One 9 mm (0.35") hole is provided at each end of the tie bar for
fixing the bracket directly to walls or ceilings or other suitable
surfaces.
Two 9 mm (0.35") holes at the d&b standard spacing of 115 mm
(4.5") are provided to allow the attachment of the Z5010 TV
spigot and the Z5012 Pipe clamp.
Each end of the bracket is equipped with a 9 mm (0.35")
elongated hole. This elongated hole allows a multitude of cabinet
positions, e.g. with a low ceiling height the cabinet can be
mounted as close as possible to the ceiling.
Angles can be set within the range of 180° (± 90° as standard).
In general, angle settings depend on the chosen position of the
cabinet within the bracket.
1.5. Assembly
Attaching the bracket to walls or ceilings
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction forces for the respective
application (wall or ceiling mounting) are listed in the following
table.
Application Rated extraction forces
Wall mounting 400 N
Ceiling mounting 100 N
To attach the bracket to walls or ceilings, use the holes shown in
the graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to Þ Chapter 2. "Fixing template"
on page 7.
Preparing the cabinet
The top and bottom panels of the loudspeaker cabinet are each
equipped with an M8 thread. The thread is covered by a dummy
cap in cabinet color.
To remove the cap, proceed as follows:
1.
Cut out the cap along the recessed spline using an
appropriate cutting knife.
2. Carefully take off the cap and ensure the cabinet coating is
not peeled off.
Fig. 3: Z5408 Mounting holes
d&b Z5408 Horizontal bracket 8S, Mounting instructions (1.2 EN) 5