ILUMINARC Ilumipod™ 42 IP - Manual (Page 25)

Technical Information
Ilumipod 42 IP Optic Series User Manual Rev. 6 21
Troubleshooting Guide
Symptom Cause(s) Action(s)
Low light intensity
Dirty lens assembly Clean the fixture regularly
Misaligned lens assembly Install/adjust lens assembly properly
Group of LEDs not illuminating
Faulty LED Replace LED board
Faulty LED driver Replace LED driver board
One LED does not illuminate
Faulty LED Replace LED board
Faulty LED driver Replace LED driver board
No LEDs illuminate
Faulty LED board Replace LED board
Faulty LED driver board Replace LED driver board
Faulty main board Replace main board
Circuit breaker/fuse keeps
tripping/blowing
Excessive circuit load Check total load placed on the electrical
circuit
Short circuit along the power wires Check for a short in the electrical wiring
Fixture does not power up
No power Check for power on power outlet
Loose or damaged power cord Check power cord
Faulty internal power supply Replace internal power supply
Fixture does not respond to
DMX
Wrong DMX addressing Check Control Panel and unit addressing
Damaged DMX cables Check DMX cables
Wrong polarity on the controller Check polarity switch settings on the
controller
Loose DMX cables Check cable connections
Faulty DMX interface Replace the Display/Main board
Faulty Display/Main board Replace the Display/Main board
DMX signal problems
Non DMX cables Use only DMX compatible cables
Bouncing signals Install terminator as suggested
Long cable / low level signal Install an optically coupled DMX splitter
right after the fixture with the strong signal
Too many fixtures Install an optically coupled DMX splitter
after unit #32 or before
Interference from AC wires Keep DMX cables separated from power
cables or fluorescent/black lights